The IES1104P series Industrial POE Switch is the ideal solution for powering remote devices such as IP phones, video cameras, wireless access points, alarms, traffic controllers, sensors and tracking devices, which are installed 100m far from a Power over Ethernet switch. In addition to transmitting data, the twisted-pair port also injects power down the cable, allowing a remote Power over Ethernet Device to operate without the need of any additional power source. All Power over Ethernet Powered Devices (IEEE 802.3af/at complaint) are supported, as the IMC1100P series can deliver a full 15.4W / 30W of power to the remote device.
Adopting advanced attenuation fiber technology, The Build-out design can be easily inserted between the connector and the adapter to bring the optical power levels within the operating range of the receiver. The front of the attenuator is a male plug connector style, allowing the attenuators to be plugged directly into receiver equipment or adaptors in patch panel. The rear is a female socket adaptor allowing a patch cord to be mated into the back of the attenuator. The versatility of this design allows the Attenuators to be placed Inline, directly in front of the receiver, or at other points in the network such as distribution frames and cabinets. Their remarkable stability over a wide temperature range (-40 ºC to +75 ºC) permits their deployment in central offices, and in remote sites such as cabinets, huts or underground vaults. Available in single mode or multimode, FC, SC, ST, LC type.
Supports up to 10.7Gbps bit rates Hot-pluggable SFP+ footprint 850nm VCSEL laser and PIN photodiode, Up to 300m for OM3-MMF transmission Compliant with SFP+ MSA and SFF-8472 with duplex LC receptacle Compatible with RoHS Single +3.3V power supply Real Time Digital Diagnostic Monitoring Operating case temperature: Standard: 0 to +70°C Industrial: -40 to +85°C
18 slot 4U Chassis with dual power supply
Up to 1.25Gbps bi-directional data links 1490nm DFP laser and PIN photo detector for 20km transmission Compliant with SFP MSA and SFF-8472 with single LC receptacle Digital Diagnostic Monitoring: Internal Calibration or External Calibration Compatible with SONET Compatible with RoHS +3.3V single power supply Operating case temperature: Standard :0 to +70°C Industrial : -40 to +85°C
Up to 1.25Gbps bi-directional data links 1550nm DFP laser and PIN photo detector for 20km transmission Compliant with SFP MSA and SFF-8472 with single LC receptacle Digital Diagnostic Monitoring: Internal Calibration or External Calibration Compatible with SONET Compatible with RoHS +3.3V single power supply
MU is a small form factor SC. It has the same push/pull style, but can fit 2 channels in the same footprint of a single SC. MU was developed by NTT. The MU connector looks a miniature SC with a 1.25 mm ferrule. It is a popular connector type in Japan
16 Port Splitter Distribution Box forselling.