Products: cwdm gbic

 

SFP-GB-T3 10 100 1000Mbps Copper SFP Transceiver New

Up to 1.25Gb/s bi-directional data links Hot-pluggable SFP footprint Extended case temperature range (0°C to +70°C ) Fully metallic enclosure for low EMI Low power dissipation (1.05 W typical) Compact RJ-45 connector assembly Access to physical layer IC via 2-wire serial bus 1000 BASE-T operation in host systems with SERDES interface 10/100/1000Mbps compliant in host systems with SGMII interface

AFS3028 10/100/1000M 24GX4GC Fiber Switch fiber switch fibre switch

The AFS3028 Unmanaged SFP Fiber Ethernet Switch is a high performance Layer 2 Gigabit Ethernet switch for service providers. The switch provides an uplink port 4*COMBO (4x10/100/1000Base-T or 4*1000Base-X SFP slot) and 24*1000BaseX SFP slot on the downstream port.

  Fiber Optic Attenuator AT-FF-FC

To ensure proper performance and to maximize the life of optical receivers, the power received by these photodetectors must fall within their dynamic or operating range. For this reason, fiber optic transmission systems often use Attenuators to reduce or balance the power in the passive optical network.

High Quality Fiber Media Converter AOM 1100D

AOM-1100D Serial 10/100M Fiber Media Converter translates the signal from a twist-pair 10/100Base-TX cable to 100Base-FX fiber optic cable, extends data transmission distance from 100m via copper cables to 120km by fiber optic cable, which supports LFP (Link Fault Pass-through) function & USB Powered.

SFP-B1245L-80 1.25Gbps SFP Bi-Di Transceiver 80km Reach TX1490 RX1550nm

Up to 1.25Gbps bi-directional data links 1490nm DFP laser and PIN photo detector for 80km transmission Compliant with SFP MSA and SFF-8472 with single LC receptacle Digital Diagnostic Monitoring: Internal Calibration or External Calibration Compatible with SONET Compatible with RoHS +3.3V single power supply Operating case temperature:Standard :0 to +70°C Industrial : -40 to +85°C

Fiber Optic Fast Connector SC UPC

SC Fiber Optic Fast Connector designed for FTTH is a new generation of fiber connector used in assembly. It can provide Open flow and Pre-cast type of products, whose optical and mechanical specification meets the standard optical fiber connector.

MPO-MTP Fiber Optical Patch Cord

MPO fiber optic patch cord is a multi-fiber patch cord with fiber count of 4, 8 or 12. Fiber optics MPO connectors use Precision molded MT ferrules, together with metal guide pins and precise housings ensuring fiber alignment when mating.  

Fiber Optic Patch Cord Pigtail

Fiber optic pigtails the typical use is to link the fiber optic cable with fiber optic equipment, the multi-pigtail with connector side is used to link the equipment, while the other side of the fan out pigtail is melted together with the fiber cable, by melting together the fiber glasses, it can reach a minimum insertion loss. Common types of fiber optic pigtails are usually with 0.9mm fiber cable diameter, and usually installed inside ODF unit. Most commonly used types are SC fiber optic pigtail, ST fiber optic pigtail, FC fiber optic pigtail, LC fiber optic pigtail, MT-RJ fiber optic pigtail, SC/APC fiber optic pigtail, and FC/APC fiber optic pigtail and E2000 fiber optic pigtail.